New and Improved LED Lamps

Beghelli is proudly committed to providing quality products that meet the highest standards. We happy to announce that we have re-engineered all our 5W and 7W MR16 LED lamps. We have also introduced a new 6V 7W LED lamp.

These improved lamps will maintain a low surge current at start-up. We cap our start up current at 10x the load at 100%. By making this improvement we ensure there will be no damage by the lamps to the charger boards when the units are loaded to capacity.

We are now using a COB LED and upgraded driver in our lamps which will provide lower heat emission, higher efficacy and will extend the life of the lamp.

Lamps are now FCC certified which means electromagnetic interference from the lamp is below approved limits. This will ensure the lamp does not cause any interference with sensitive electrical equipment such as medical or communication devices.

Often, when other LED lamps’ supply voltage is reduced, it also lowers the wattage and becomes dimmer. With our new models, that will not be an issue – there is consistent light output even if battery voltage drops. Power does not increase as voltage falls which could reduce run times, blow fuses or damage to the charger boards. You can trust that when we state our lamps are 5W or 7W, that is the maximum wattage they will draw and the light output will remain the same throughout the entire operating voltage range of the lamps.